iO HVAC Controls iO-CL75 Temp Stat 75 Degree Thermostat, Cooling, Min Order Qty 10

(No reviews yet) Write a Review

Usually Ships In 2-4 Business Days

Free ground shipping to the lower 48 states

Product ID:
0.10 (Lbs.)
Ships By:
Free Ground
Ships From:
Indiana - Direct From iO HVAC Controls

choose options:

Frequently Bought Together

Please choose options for all selected products

  • Choose Options


iO HVAC Controls iO-CL75 Temp Stat Features: 
- 75 Degree.
- Temporary Construction Thermostat. 
iO HVAC Controls Temp Stats are low cost, non-adjustable, temporary construction thermostats preset to a given temperature. Available in heating or cooling models. Use in place of a regular thermostat that can be stolen, damaged or tampered with. Save on heating and cooling costs during construction or anywhere you need to maintain a given temperature.
Frequently Asked Questions:
How is Temp-Stat wired?
It is simply connected across the “W” and “R” terminals (just like any heat-only thermostat).
• Is there any limitation on the thermostat wire run length?
No; Temp-Stat is not an electronic sensor, it is a special bimetal thermostat with the same limitations of any other standard thermostat.
• What type of control circuit should be used with Temp-Stat?
Use it with only 24 Volt control circuits with a maximum current of 1.0 Amp. Use a relay kit (CS-RY-115 or CS-RY-220) if controlling a line voltage circuit.
• How is Temp-Stat wired for a heat pump?
Typically the resistance heat is operated during construction; therefore Temp-Stat would be wired across “W” and “R”. Depending on the equipment, a jumper may be required between “W” and “G” at the air handler to control the fan; however, if the compressor is to be used for temporary heat, simply wire across “Y” and “R” (assuming the changeover valve is energized on a call for cooling).
• Can a simple switch be used in series with Temp-Stat to turn the furnace on and off?
Yes; however, the easiest way is to use the “ssu” switch that is almost always installed at the side of the furnace to turn it on and off.
• Can a Temp-Stat be used for cooling applications?
Yes; however, a cooling version (CL-70, CL-75, CL-80) must be used because it “makes” on a rise in temperature. It is recommended that a 2-wire short cycle timer be installed in the control circuit of the cooling unit (some units may have this built in).
• What is the expected life of a Temp-Stat?
It is the same as any other standard thermostat.
• Do heat, moisture and vibration cause any problems?
Heat and moisture do not affect Temp-Stat; however, vibration could cause it to work improperly. It is recommended that it not be mounted on any vibrating surface.
• What is the temperature differential of Temp-Stat?
11/2 degree Fahrenheit.
• What is the warranty?
Temp-Stat has a one (1) year warranty.