Fernox 59480 Boiler Commissioning Kit, Treats 26 Gallons
Fernox
(No reviews yet)
Write a Review
Write a Review
Fernox
Fernox 59480 Boiler Commissioning Kit, Treats 26 Gallons
$107.00
5 In Stock, Orders Placed By 3pm EST Ship Same Day (Weekends And Holidays Excluded)
Free ground shipping to the lower 48 states
- Product ID:
- Fernox-59480
- Weight:
- 4.00 (Lbs.)
- Ships By:
- Free Ground, Or Choose Expedited Shipping At Checkout
- Ships From:
- NorthStock In Massachusetts
Description:
Fernox Boiler Commissioning Kit 59480.
Product Code: 59480
Each box contains 1x 57880 F1 Protector, 1x 57882 F3 cleaner, 4x pH strips, 1x Fernox Protector test kit. Treats 26 gallons.
BOILER COMMISSIONING KIT
- Maintain the design specification and energy efficiency
- Restore energy efficiency
- Inhibit the formation of scale and sludge
- Minimize corrosion of system metals
Good practice dictates that hydronic central heating systems should be thoroughly cleaned and flushed before installing a new boiler, after which a chemical inhibitor should be added to ensure the system is protected from corrosion, scale and sludge build-up. These procedures should also be employed when major work is carried out on a system. A clean, protected system helps ensure that the heat generated by the boiler is transmitted efficiently into the house over the long term.
Test Procedure
1. Prior to cleaning and flushing, use the enclosed pH test strips and color coded chart to measure the initial pH of the system water as a reference guide.
2. Check boiler manufacturer’s instructions regarding system cleaning prior to commencing work.
3. Best practice is to clean and flush the heating system with the old boiler still installed prior to installation of a new boiler.
4. Drain the system water.
5. Fill the system with fresh water.
6. Add Fernox Cleaner F3 into the system.
7. Run up to temperature for a minimum of one hour. Ensure that all the system is fully open to allow complete cleaning. Check that all zones including all radiators (if present), are heating up and there are no cold spots.
8. Drain and flush the system thoroughly in both directions to remove the cleaning agent and any debris until the water runs clean. Use of a power flusher is preferred. 9. Fill the system with fresh water.
10. Add Fernox Protector F1 to provide long term protection against corrosion and limescale, and maintain efficiency. Circulate around the system for equal distribution.
11. Check the system pH level using a provided pH test strip and color coded chart. The pH value of the system water must be between 7 and 8.5.
12. If the pH test strips do not show positive results, add additional Fernox Protector F1. Repeat both tests with fresh test strips until achieving the desired results.
Packaging, Handling and Storage
The Fernox Boiler Commissioning Kit is supplied as with full instructions and is non-hazardous reagents. Keep out of reach of children.
Contents:
- 1 x Fernox Protector F1 17.6oz (500ml)
- 1 x Fernox Cleaner F3 17.6oz (500ml)
- 4 x Fernox pH Test Strips
- 1 x Fernox Protector test kit
- Instruction Leaflet
Videos Hide Videos Show Videos
Related Units, Accessories, And OEM Replacement Parts
from our fans
"We have been ordering parts from NorthStock and have been very pleased with the service. The availability shown on the website has always been actual in-stock items, product has always shipped as promised. Knowing you have a vendor you can depend on is key, NorthStock is our first point of contact. Customer service on a level that you do not see very often this day and age. Thanks NorthStock!"
CHRYSTAL FROM FLORIDA