![Control Devices TC12-1AA018 Throttle Control, Standard Body With Vibra Seal, 18 Inch Cable Length, 1/8 Inch NPT Inlet, Min Order Qty 10 Control Devices TC12-1AA018 Throttle Control, Standard Body With Vibra Seal, 18 Inch Cable Length, 1/8 Inch NPT Inlet, Min Order Qty 10](https://cdn11.bigcommerce.com/s-kf91vy1qfw/images/stencil/500x659/products/143928/574098/control-devices-tc12-1aa018-throttle-control-standard-body-with-vibra-seal-18-inch-cable-length-18-inch-npt-inlet-min-order-qty-10__84848.1697803890.jpg?c=1)
Control Devices TC12-0AA018 Throttle Control, Standard Body, 18 Inch Cable Length, 1/8 Inch NPT Inlet, Min Order Qty 10
Control Devices
$27.46
Usually Ships In 1-2 Weeks
Free ground shipping to the lower 48 states
- Product ID:
- Control-Devices-TC12-0AA018
- Weight:
- 1.00 (Lbs.)
- Ships By:
- Free Ground
- Ships From:
- Missouri - Direct From Control Devices, LLC
Description:
Control Devices TC12-0AA018 Throttle Control, Standard Body, 18 Inch Cable Length, 1/8 Inch NPT Inlet Features:
- 18 inch Cable length.
- 1/8 inch NPT inlet.
- 18 inch Cable length.
- 1/8 inch NPT inlet.
- Min pressure 60 PSI.
- Max pressure 250 PSI.
- Max temp 250F.
- Max pressure 250 PSI.
- Max temp 250F.
Additional Features
This valve is used with gas engine-driven compressors to save fuel and reduce engine and compressor wear by causing the engine to idle when the continuous run control reaches its cut-out setting. Its 1/8 inch NPT inlet is connected to the throttle control port of a vent unloader or the tee of a head unloader line on a pilot valve, while the cable end is attached to the engine's throttle linkage with the cable housing anchored using the supplied cable clamps. At the cut-out setting, the valve's piston extends the control cable to push the throttle lever into idle, and at the cut-in setting, the valve is vented, allowing the throttle to return to the original, full-speed position.
This valve is used with gas engine-driven compressors to save fuel and reduce engine and compressor wear by causing the engine to idle when the continuous run control reaches its cut-out setting. Its 1/8 inch NPT inlet is connected to the throttle control port of a vent unloader or the tee of a head unloader line on a pilot valve, while the cable end is attached to the engine's throttle linkage with the cable housing anchored using the supplied cable clamps. At the cut-out setting, the valve's piston extends the control cable to push the throttle lever into idle, and at the cut-in setting, the valve is vented, allowing the throttle to return to the original, full-speed position.
Videos Hide Videos Show Videos
from our fans
"We have been ordering parts from NorthStock and have been very pleased with the service. The availability shown on the website has always been actual in-stock items, product has always shipped as promised. Knowing you have a vendor you can depend on is key, NorthStock is our first point of contact. Customer service on a level that you do not see very often this day and age. Thanks NorthStock!"
CHRYSTAL FROM FLORIDA