![Control Devices CS12-000 Cold Start Valve, 25 PSI, 1/8 Inch NPT Inlet, 1.15 SCFM, Min Order Qty 100 Control Devices CS12-000 Cold Start Valve, 25 PSI, 1/8 Inch NPT Inlet, 1.15 SCFM, Min Order Qty 100](https://cdn11.bigcommerce.com/s-kf91vy1qfw/images/stencil/500x659/products/143661/573772/control-devices-cs12-000-cold-start-valve-25-psi-18-inch-npt-inlet-1.15-scfm-min-order-qty-100__83158.1697803394.jpg?c=1)
Control Devices CS25-000 Cold Start Valve, 25 PSI, 1/4 Inch NPT Inlet, 2.5 SCFM, Min Order Qty 100
Control Devices
$4.85
Usually Ships In 1-2 Weeks
Free ground shipping to the lower 48 states
- Product ID:
- Control-Devices-CS25-000
- Weight:
- 1.00 (Lbs.)
- Ships By:
- Free Ground
- Ships From:
- Missouri - Direct From Control Devices, LLC
Description:
Control Devices CS25-000 Cold Start Valve, 25 PSI, 1/4 Inch NPT Inlet, 2.5 SCFM Features:
- 25 PSI.
- 1/4 inch NPT inlet.
- 25 PSI.
- 1/4 inch NPT inlet.
- 2.5 SCFM.
Additional Features
These cold-start valves bleed air from the compressor head during the first few pump revolutions, reducing torque requirements for starting a motor. They are especially helpful on oil-lubed pumps that may be subject to low temperatures and low starting voltages, like contractor units that may sit outside overnight, connected to a long extension cord.
Install these valves into any convenient port upstream of the tank check valve, typically in a 1/8" NPT port in the check valve, a port tapped in the head of the pump, or a tee in the discharge line. When the discharge line is at zero pressure, the CS valve is open, then when the pump starts, air flows out of the CS valve into the atmosphere. As the pump speed and discharge pressure increase, the valve snaps shut and stays closed until the end of the pump-up cycle. Upon unloading the head, the valve re-opens, ready for the next start-up.
These cold-start valves bleed air from the compressor head during the first few pump revolutions, reducing torque requirements for starting a motor. They are especially helpful on oil-lubed pumps that may be subject to low temperatures and low starting voltages, like contractor units that may sit outside overnight, connected to a long extension cord.
Install these valves into any convenient port upstream of the tank check valve, typically in a 1/8" NPT port in the check valve, a port tapped in the head of the pump, or a tee in the discharge line. When the discharge line is at zero pressure, the CS valve is open, then when the pump starts, air flows out of the CS valve into the atmosphere. As the pump speed and discharge pressure increase, the valve snaps shut and stays closed until the end of the pump-up cycle. Upon unloading the head, the valve re-opens, ready for the next start-up.
Videos Hide Videos Show Videos
from our fans
"We have been ordering parts from NorthStock and have been very pleased with the service. The availability shown on the website has always been actual in-stock items, product has always shipped as promised. Knowing you have a vendor you can depend on is key, NorthStock is our first point of contact. Customer service on a level that you do not see very often this day and age. Thanks NorthStock!"
CHRYSTAL FROM FLORIDA