Markel F1FUH15C03 Horizontal Fan Forced Electric Unit Heater, 15 KW, 208V/1Ph
Markel
Usually Ships In 2-3 Weeks
Free ground shipping to the lower 48 states
- Product ID:
- Markel-F1FUH15C03
- UPC:
- 686334644655
- Weight:
- 54.00 (Lbs.)
- Ships By:
- Free Ground
- Ships From:
- Tennessee - Direct From Markel
- Model Number: F1FUH15C03.
- Air Throw: 45 Ft.
- Amp: 72.1.
- BTU: 51200.
- CFM: 800.
- Control Voltage: 208.
- KW: 15.
- Recommended Mounting Height: 10 Ft.
- Phase: 1.
- Temperature Rise: 59F.
- Voltage: 208.
- Weight (lbs): 54.
- Color: Beige.
- Optional factory installed summer fan switch to operate the fan only.
- Optional factory installed fan delay switch to purge all residual heat from the unit after the heating element has cycled off.
- Optional factory installed disconnect switch.
- Powder coated epoxy finish for corrosive atmospheres.
- Made in U.S.A.
- California residents see Prop 65 Warnings.
HEATING ELEMENT: Circular copper clad steel sheath element with continuously brazed steel fins formed to match the air delivery pattern of the fan blade.
OVERHEAT PROTECTION: All units come equipped with automatic resetting type limit controls to de-energize the heater should an over-temperature situation occur.
FAN and MOTOR: Totally enclosed, single phase, permanently lubricated, thermally protected motors with unit bearings on 3 KW - 10 KW models and sleeve bearings on 12.5 KW - 48 KW models - mounted with rubber insulators to minimize vibration and noise. Fan assembly enclosed by a heavy gauge, close spaced, chrome plated wire guard.
LOUVER ASSEMBLY: Louvers are individually adjustable for directional control of air flow and the entire assembly can be repositioned in the field from down flow to up flow or left / right directional air flow.
TEMPERATURE CONTROLS: 20 KW through 48 KW units and all 480V have built in 24 Volt transformer for low voltage remote thermostat application. 25 KW through 48 KW models available in 2-stage on special order (consult factory).
INSTALLATION: Unit Heaters can be mounted with the motor shaft from horizontal to downward at 45 degrees off horizontal. Pre-drilled holes and installed threaded nuts provided to allow hanging by threaded rods - 1/4 inch for units up to 15 KW and 5/16 inch for 20 KW units and larger. Optional wall / ceiling mounting brackets are available for all units.
From Our
Fans
"We have been ordering parts from NorthStock and have been very pleased with the service... Customer service on a level that you do not see very often this day and age. Thanks NorthStock!"
CRYSTAL FROM FLORIDA
"This company cares about their products but also cares about customer satisfaction. I will continue to order from them for all my needs."
pat from pennsylvania
"I ordered a part to be shipped to Arkansas. NorthStock had the best price that I could find. They shipped the part fast and it (fan motor) runs quieter than when new."
tim from arkansas
"Excellent customer service and quicker than expected delivery of a hard to source part. Highly recommended."
sean from massachusetts
"Had exactly what I needed in stock. Ordered on a Wednesday and it arrived Friday. Could not ask for better service. Fast Shipping and a very nice website!""
scott from maryland
"Fast shipping and excellent customer service. Will continue to do business with them."
andrew from missouri