QMark CWH1157DSAF Heater, 1,500/750/1,125/562W, 277/240V 1PH 6/3/5/3A
QMark
(No reviews yet)
Write a Review
Write a Review
QMark
QMark CWH1157DSAF Heater, 1,500/750/1,125/562W, 277/240V 1PH 6/3/5/3A
$383.72
Usually Ships In 3-5 Weeks
Free ground shipping to the lower 48 states
- Product ID:
- QMark-CWH1157DSAF
- UPC:
- 685360163000
- Weight:
- 11.00 (Lbs.)
- Ships By:
- Free Ground
- Ships From:
- South Carolina - Factory Direct
Description:
QMark CWH1157DSAF Heater, 1,500/750/1,125/562W, 277/240V 1PH 6/3/5/3A
This fan-forced wall heater provides an architectural accent while delivering reliable comfort for small spaces. Its unique design makes it a welcome feature in any room, delivering robust warmth to all within.
QMark CWH Series Architectural Small Wall Heater Features:
- Contemporary bar-stock grille designed to provide optimized airflow.
- Contemporary bar-stock grille designed to provide optimized airflow.
- Heating element is heavy duty steel fins brazed to steel sheathed tubular elements in a grid pattern that covers the entire discharge area.
- FAN DELAY: On a call for heat, element is energized but fan is delayed until element is warm, eliminating the circulation of cold air during start up. When the thermostat is satisfied, the element is de-energized, but the fan continues until all heated air is discharged providing longer component life and higher comfort level.
- Manual reset thermal overheat protector disconnects power in the event of accidental blockage.
- Built-in power on/off switch for added safety during maintenance and built in tamper-resistant thermostat
- Designed for easy installation. Heater is mounted prior to wiring. Both hands are free to make field connections in roomy compartment.
- Motor is totally enclosed, impedance protected with permanently lubricated bearings.
- Airflow system maximizes air volume at minimum noise level; 65 CFM.
- Rugged louvered commercial grade steel Architectural grille creates downflow air pattern.
- This heater is designed for installation in 2 x 4 or larger wall sections using the wall box provided.
- The heater may also be surface mounted to the wall by using the Surface Mounting Frame (order separately).
- The heater may be wired with standard building wire (60°C). Refer to Statuary Bronze durable polyester powder coat finish and aluminum frame.
MOUNTING LIMITATIONS:
1. Do not install heater closer than 4 inches from floor.
2. Do not install heater behind towel rack, behind door, in floor, in ceiling, in closet, or where air flow may be obstructed.
Related Units, Accessories, And OEM Replacement Parts
